D-Link DES-3828 Product Manual - Page 421

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 60 MLD SNOOPING COMMANDS The MLD snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command config mld_snooping config mld_snooping mrouter_ports enable mld_snooping disable mld_snooping show mld_snooping show mld_snooping group show mld_snooping forwarding show mld_snooping mrouter_ports Parameters [ |all] { node_timeout | router_timeout | done_timer | state [enable|disable] | fast_done [enable|disable] } [add|delete] {forward_mcrouter_only} {forward_mcrouter_only} {vlan } {vlan } {vlan } {vlan } { [static|dynamic]} Each command is listed, in detail, in the following sections. config mld_snooping Purpose Syntax Description Parameters Restrictions Used to configurer MLD snooping on the switch. config mld_snooping [ |all] { node_timeout | router_timeout | done_timer | state [enable|disable] | fast_done [enable|disable] } The config mld_snooping command configures MLD snooping on the switch. vlan_name - The name of the VLAN for which MLD snooping is to be configured. all - Specifies that all VLANs configured on the switch will be configured. node_timeout - Specifies the amount of time that must pass before a link node is considered to be not a listener anymore. The default is 260 seconds. router_timeout - Specifies the maximum amount of time a router will remain in the switch's can be a listener of a multicast group without the switch receiving a node listener report. The default is 260 seconds. done_timer - Specifies the maximum amount of time a group will remain in the switch after receiving a done message of the group without receiving a node listener report. The default setting is 2 seconds. state - Allows you to enable or disable the MLD snooping function for the chosen VLAN. fast_done - enable or disable MLD snooping fast_done function.If enable, the membership is immediately removed when the system receive the MLD done message. Only Administrator or Operator-level users can issue this command. Usage Example: 417