D-Link DES-3828 Product Manual - Page 429
config loopdetect ports, enable loopdetect
UPC - 790069276811
View all D-Link DES-3828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 429 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual Example usage: To set recover_time 0 , interval 20 mode vlan-based: DES-3800:admin# config loopdetect recover_timer 0 interval 20 vlan-based Command: config loopdetect recover_timer 0 interval 20 vlan-based Success. DES-3800:admin# config loopdetect ports Purpose Syntax Description Parameters Restrictions Used to configure loop-back detection function for the port on the switch. config loopdetect ports [| all] state [enable | disable ] The config loopdetect port command is used to setup the loop-back detection function for the interface on the switch. portlist - Specifies a range of ports to be configured. all - For set all ports in the system , you may use "all" parameter. state - Allows loop-detect to be enabled or disabled for the ports specified in the port list. The default is disabled. Only Administrator or Operator-level users can issue this command. Example usage: To set state enable: DES-3800:admin# config loopdetect ports 1-5 state enable Command: config loopdetect ports 1-5 state enable Success. DES-3800:admin# enable loopdetect Purpose Syntax Description Parameters Restrictions Used to globally enable loopdetect function on the switch. enable loopdetect The enable loopdetect command allows the Loop Detection Function to be globally enabled on the switch. The default value is disabled. None. Only Administrator or Operator-level users can issue this command. 425