D-Link DFE-854 User Guide
D-Link DFE-854 - Transceiver - External Manual
UPC - 790069212376
View all D-Link DFE-854 manuals
Add to My Manuals
Save this manual to your list of manuals |
D-Link DFE-854 manual content summary:
- D-Link DFE-854 | User Guide - Page 1
Fast Ethernet Transceivers Model DFE-853, DFE-854 User's Guide August, 1997 6DFE853...01 Rev.01 Printed in Taiwan RECYCLABLE 1 - D-Link DFE-854 | User Guide - Page 2
as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems Inc., as stipulated by the United States Copyright Act this user's guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to - D-Link DFE-854 | User Guide - Page 3
, under normal use and service, for the following lengths of time from the date of purchase from D-Link or its authorized reseller: If a product does not operate as warranted during the applicable warranty period, D-Link shall, at its option and expense, (1) repair the defective product or part - D-Link DFE-854 | User Guide - Page 4
wrapped in the original or similar shipping package to ensure that it will not be damaged during shipment. When returning the defective product to D-Link for service, the RMA number must be marked on the outside of the shipping package. Any product returned without an RMA number shall be rejected - D-Link DFE-854 | User Guide - Page 5
service charge is levied or not, and the charged amount, read the RMA that is returned to Customer, or ask the D-Link office when an RMA is requested. 5 - D-Link DFE-854 | User Guide - Page 6
ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION MAINTENANCE OR USE OF D-LINK'S PRODUCTS. D-LINK SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST - D-Link DFE-854 | User Guide - Page 7
PRODUCT, HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY. THIS LIMITATION WILL APPLY EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. IF YOU PURCHASED A D-LINK PRODUCT IN THE UNITED STATES, SOME STATES DO NOT ALLOW THE LIMITATION OR EXCLUSION OF LIABILITY FOR INCIDENTAL OR - D-Link DFE-854 | User Guide - Page 8
guide provides basic information for installation and use of D-Link Fast Ethernet transceiver models DFE-853 and DFE-854. Introduction D-Link Fast Ethernet transceiver models DFE-853 and DFE-854 represent the best value on the market. These transceivers are IEEE 802.3u compliant and support - D-Link DFE-854 | User Guide - Page 9
(full-duplex) and 412 meters (half-duplex). The DFE-854 transceiver only operates at 100Mbps. Network Cables Supported The connectors and network cables supported by these two transceivers are listed in the following table: Model DFE-853 DFE-854 Connectors MII RJ-45 MII Fiber SC Type of Network - D-Link DFE-854 | User Guide - Page 10
• Humidity: 10- 90% (non-condensing) • EMI certification: FCC, CE, VCCI and C-Tick. DFE-854 100BASE-FX Fast Ethernet Transceiver • Conforms to the IEEE 802.3u 100BASE-FX standard. • 100 Mbps data transfer rate. • Supports transmission distances up to 2 km (full-duplex) and 412 meters (half-duplex - D-Link DFE-854 | User Guide - Page 11
VCCI and C-Tick DIP Switch The following figure shows the DIP switch on both DFE-853 and DFE-854 transceivers. Switches 1 through 5 Switches 1 through 5 are used to set a PHY address. For both the DFE-853 and the DFE-854, the user can select a PHY address (see appendices) number from 0 through 31 if - D-Link DFE-854 | User Guide - Page 12
advertisement ability; for the DFE-854, switch F is used to set halfor full-duplex mode. The FDX/HDX Indicator shows the result. For the DFE-8533: set the switch link partner if switch F is set to the OFF position. The DFE-853 will advertise 10Mbps/Full-duplex and 10-Mbps/Half-duplex to its link - D-Link DFE-854 | User Guide - Page 13
DFE-854. 2. Col Indicator (yellow) A light up to indicate a collision has occurred. 3. FDX/HDX Indicator (green) Steady green indicates full-duplex selected. Dark indicates half-duplex selected. 4. Link/Rx Indicator (green) Steady green indicates that a valid link exists. Flashing green indicates - D-Link DFE-854 | User Guide - Page 14
-TX TP cable connected to the transceiver. The transceiver's MII connector is attached to an MII host device such as a hub or a switch. DFE-854 The DFE-854 Fiber Optic Fast Ethernet transceiver can be used for making connections between an MII port and fiber optic network cable. The figure below - D-Link DFE-854 | User Guide - Page 15
Appendices: Appendix A Select a PHY address(for DFE-853 and DFE-854) Switches 1 through 5 are used to set PHY addresses. PHY Address DIP Switch # SW1 SW2 SW3 SW4 SW5 00h OFF OFF OFF OFF OFF 01h OFF - D-Link DFE-854 | User Guide - Page 16
Appendix B Link Distance Maximum distance between devices connected through DFE-853 or DFE-854 transceivers are as follows. For further help, please contact the establishment from which you purchased your transceiver. Network Devices with DFE-853 Transceivers Maximum Distance Switch-Switch 100M( - D-Link DFE-854 | User Guide - Page 17
NOTE 17 - D-Link DFE-854 | User Guide - Page 18
#2, Allee de la Fresnerie 78330 Fontenay Le Fleury France TEL: 33-1-3023-8688 FAX: 33-1-3023-8689 D-LINK A/B World Trade Center P. O. Box 70396, 107 24 Stockholm TEL: 46-8-700--6211 FAX: 46-8-219-640 D-LINK DENMARK Naverland 2 DK-2600 Glostrup Copenhagen, Denmark TEL:45-43-969-040 FAX:45-43-424-347 - D-Link DFE-854 | User Guide - Page 19
Telephone Fax Reseller's full address Answers to the following questions help us to support your product: 1. Where and how will the product primarily be used? † Communication †VAR †System house/company †Other 5. Would you recommend your D-Link product to a friend? †Yes †No †Don't know yet 6. - D-Link DFE-854 | User Guide - Page 20
1
Fast Ethernet Transceivers
Model DFE-853, DFE-854
User’s Guide
August, 1997
6DFE853...01 Rev.01
Printed in Taiwan
RECYCLABLE