D-Link DGS-6600-48T Product Manual - Page 130

DGS-6604 m color-aware color-aware color-aware Use the color-aware command to specify the color aware mode for a class. Use the no form of the command to set the class to color blind mode. no color-aware Syntax None Default color-blind mode Command Mode Usage Guideline Examples Policy-map class configuration The color-aware command specifies that the configured policer for the traffic class will operate in color aware mode. In color aware mode, the initial color of the packet and the policer metering result determines the final color. The initial color of the packet is mapped from the incoming DSCP based on the DSCP to color map if the receiving port trusts DSCP. If the receiving port trusts CoS, then the initial color is mapped from the incoming CoS based on the CoS to color map If the configured policer operates in color blind mode, then the policer metering result determines the final color. The following example creates the policy map pcolor-map1 and configures the policy of running color aware mode and two rate policing for the class1 class in the policy map. Switch(config)# policy-map pcolor-map1 Switch(config-pmap)# class class1 Switch(config-pmap-c)# color-aware Switch(config-pmap-c)# police cir 500000 bc 10000 pir 1000000 be 10000 exceed-action set-dscp-transmit 2 violate-action drop Switch(config-pmap-c)# exit Switch(config-pmap)# exit The following example attach the pcolor-map1 policy map to eth3.1 and sets the port to trust CoS and defines the CoS to color map. Switch(config)# interface eth3.1 Swtich (config-if)# service-policy pcolor-map1 Swtich (config-if)# qos trust cos Swtich (config-if)# qos map cos-color 1-7 to green Swtich (config-if)# exit Verify the settings by entering the show policy-map command. CLI Reference Guide 120