D-Link DGS-6600-48T Product Manual - Page 168

DGS-6604 mm dot1v binding protocol-group dot1v binding protocol-group Use the dot1v binding protocol-group interface configuration command to set a protocol VLAN group and bind VLAN of the port. The no form of this command can remove the port from the specific protocol VLAN group. dot1v binding protocol-group GROUP-ID vlan VLAN-ID no dot1v binding protocol-group [ GROUP-ID ] Syntax Description GROUP-ID Specifies the protocol group ID to bind or remove. The valid GROUP-ID range is 1 to 16. VLAN-ID Specifies the VLAN identifier of the protocol VLAN. Single VLAN ID is valid. Default Command Mode Usage Guideline Example The default port is not bound to any protocol VLAN group. Interface configuration The valid interface for this command can be either a physical port or a portchannel. Use the dot1v binding protocol-group command to bind a protocol VLAN group with a VLAN ID. As a result, the packet that matches the specified protocol group will be associated with the VLAN binding with this group. The VLAN does not need to exist for the command to succeed. If the GROUP ID is not specified when using the command no dot1v binding protocol-group, the switch will remove all the protocol group and VLAN bindings at the specified interface. This example shows how to bind a protocol VLAN group 10, VLAN id 3000 of ethernet port 3.2 Switch(config)# interface eth3.2 Switch(config-if)# dot1v binding protocol-group 10 vlan 3000 Verify the settings by entering the show dot1v interface command. CLI Reference Guide 158