D-Link DGS-6600-48T Product Manual - Page 173

DGS-6604 mm dot1x default dot1x default Using this command resets the configurable 802.1X parameters to the default values. dot1x default Syntax None Default The default values are listed as following: The authorization state on a controlled port is auto. The direction of the traffic through a controlled port is bidirectional. The number of maximum retransmit times which the switch will retransmit an EAP request frame to the supplicant before restarting the authentication process is 2. The quiet-period, reauth-period, server-timeout, supp-timeout, and tx-period are 60, 3600, 30, 30, and 30 seconds, respectively. Periodic re-authentication is disabled. Command Mode Interface configuration Usage Guideline This command is only valid on physical port interface. Example The following example shows how to reset the IEEE 802.1X parameters on port eth4.1. Switch# configure terminal Switch(config)# interface eth4.1 Switch(config-if)# dot1x default Verify the settings by entering the show dot1x auth-configuration command. CLI Reference Guide 163