D-Link DGS-6600-48T Product Manual - Page 180

DGS-6604 mm dot1x port-control dot1x port-control Use this command to manually control the authorization state on a specific port. dot1x port-control { auto | force-authorized | force-unauthorized } Syntax Description auto The state (authorized or unauthorized) for a specific port is determined according to the outcome of the authentication. force-authorized Specifies to force the port to change to the authorized state. The port allows access and all authentication packets are ignored. force-unauthorized Specifies to force the port to change to the unauthorized state. The port is blocked and all authentication packets are ignored. Default Command Mode Usage Guideline Example auto Interface configuration This command is valid only for physical port interface. Global 802.1x authentication function should be enabled using the dot1x system-auth-control command on page 173 before enabling 802.1X authentication on a specific port. This example shows how to deny all access on eth4.1. Switch# configure terminal Switch(config)# interface eth4.1 Switch(config-if)# dot1x port-control force-unauthorized Verify the settings with the show dot1x auth-configuration command. CLI Reference Guide 170