D-Link DGS-6600-48T Product Manual - Page 193

DGS-6604 m erpi enable erpi enable Use the erpi enable command to enable the ERP instance in an ERPS domain. Use the no form of this command to disable the ERP instance. erpi INSTANCE-ID enable no erpi INSTANCE-ID enable Syntax Description INSTANCE-ID Specifies the identifier of ERP instance. The vlaid range is 1 to 4095. Default Command Mode Usage Guideline Example Disabled ERPS domain configuration mode Use the command to enable the administrative state of an EPR instance. The RAPS VLAN, ring ports, RPL setting must be configured first before the ERP instance can be enabled. The command does not take effect under the following conditions. The ERP instance is still in operational disabled state. 1.The configured R-APS controlled VLAN does not exist. 2.The configured ring ports are not the tag member port of the R-APS controlled VLAN. In addition to R-APS controlled VLAN and ring ports, the configuration of service protected VLANs and RPL related settings are fundamental for the setup of an ERP instance. The following example shows how to enable ERP instance 1 in ERPS domain campus: Switch(config)# erps domain campus Switch(config-erps-domain)# erpi 1 enable Switch(config-erps-domain)# The following example shows how to disable ERP instance 1 in ERPS domain campus: Switch(config)# erps domain campus Switch(config-erps-domain)# no erpi 1 enable Switch(config-erps-domain)# CLI Reference Guide 183