D-Link DGS-6600-48T Product Manual - Page 198

DGS-6604 m erpi ring-port erpi ring-port Use the erpi ring-port command to configure the ring ports of an ERP instance. Use the no form of this command to remove the ring port setting. erpi INSTANCE-ID ring-port {east | west} {shared | INTERFACE-ID} no erpi INSTANCE-ID ring-port {east | west | shared} Syntax Description INTERFACE-ID Specifies the identifier of the ERP instance. The valid range is 1 to 4095. east Specifies the port as the east ring port. west Specifies the port as the west ring port. shared Specifies the port as a shared ring port for the sub ERP instance. INTERFACE-ID Specifies the interface of configured ring port, it can be a physcial port or a portchannel interface. Default Command Mode Usage Guideline Example Not configured ERPS domain configuration mode Use the command to configure the ring ports for the ERP instance. For each ERP instance, two ring ports, east ring port and west ring port need to be configured. The ring port should be configured as the tag member ports of the R-APS controlled VLAN. The following example shows how to configure interface "eth3.1" as the east ring port of ERP instance 1: Switch(config-erps-domain)# erpi 1 ring-port east eth3.1 Switch(config-erps-domain)# The following example shows how to configure interface "eth3.2" as the west ring port of ERP instance 1: Switch(config-erps-domain)# erpi 1 ring-port west eth3.2 Switch(config-erps-domain)# The following example shows how to configure interface "port-channel1" as the east ring port of ERP instance 1: Switch(config-erps-domain)# erpi 1 ring-port east port-channel1 Switch(config-erps-domain)# CLI Reference Guide 188