D-Link DGS-6600-48T Product Manual - Page 206

DGS-6604 m errdisable recovery errdisable recovery Use the errdisable recovery command to enable and configure the error recovery function. Use the no command to disable the auto recovery for causes or to return interval to default setting for causes. errdisable recovery cause {all | loopback-detection } [ intervalSECONDS ] no errdisable recovery cause {all | loopback-detection } [ interval ] Syntax Description all Specifies the configure auto recovery for all causes. loopback-detection Specifies the configure auto recovery of error report caused by loopbackdetection intervalSECONDS Specifies the time, in seconds, to recover the port from an error state caused by the specified module. The valid value is 30 to 86400. Default Command Mode Usage Guideline Auto recovery is disabled for all causes If enabled, the Interval is 300 seconds Global configuration A port can be put in error disabled state (an operational state that is similar to the link-down state) by causes such as loopback detection. A port in error disabled state can not transmit nor receive any packets. An error disabled port can be either manual recovered or automatically restored by using this command. The user can enter shutdown and then no shutdown commands to recover an interface manually from the error-disabled state. If auto recovery is enabled for a specific cause, the port error disabled by that caused will be auto recovered once the cause have timed out. Example This example shows how to set the recovery timer to 200 seconds for port loopback-detection. Switch# configure terminal Switch(config)# errdisable recovery cause loopback-detection interval 200 Switch(config)# end CLI Reference Guide 196