D-Link DGS-6600-48T Product Manual - Page 211

DGS-6604 m gvrp advertise (Interface) gvrp advertise (Interface) Use the gvrp advertise command to specify that this VLAN will be advertised out by GVRP protocol. Use no gvrp advertise to disable this function. gvrp advertise [ VLAN-ID [ , | - ] ] no gvrp advertise [ VLAN-ID [ , | - ] ] Syntax Description VLAN-ID [ , | - ] (Optional) Specifies a VLAN. The range is 1 to 4094. Specify a single VLAN ID, a range of VLANs separated by a hyphen, or a series of VLANs separated by comma. Default Command Mode Usage Guideline Example Advertise Interface configuration Use the gvrp advertise interface configuration command to enable the specified VLANs' GVRP advertise function on the specified interface. If no VLAN ID is specified, the advertise function of all VLANs to which the specified interface belongs will be enabled. Both physical port and port-channel interfaces are valid for this command. If a physical port is member of a port-channel, then this command should return an error message to indicate it. The GVRP advertise function cannot be enabled when the interface is in access mode. This example shows how to enabled advertise function of VLAN 1000 at interface Ethernet eth4.1. Switch(config)# interface eth4.1 Switch(config-if)# gvrp advertise 1000 Verify the settings by entering the show gvrp configuration command. CLI Reference Guide 201