D-Link DGS-6600-48T Product Manual - Page 214

DGS-6604 m gvrp forbidden gvrp forbidden Use the gvrp forbidden command to specify the port as a forbidden member. Use the no gvrp forbidden command to remove the port as a forbidden member. gvrp forbidden no gvrp forbidden Syntax None Default None Command Mode Interface configuration Usage Guideline The physical port and port-channel interfaces are both valid for this command. If a physical port is a member of a port-channel, entering the command returns an error message. If multiple interfaces are specified, the command can be executed partially. Error messages are sent if the interfaces fail to execute this command. When the gvrp forbidden command is configured, all VLANs will be forbidden except the default VLAN (1) of this port. Example If some VLANs have already been defined as allowable VLANs for the port, then these VLAN memberships will be removed when issuing the gvrp forbidden command. These memberships will not be recovered even when the no gvrp forbidden command is applied. This example shows how to set Ethernet eth3.1 as a GVRP forbidden port. Switch(config)# interface eth3.1 Switch(config-if)# gvrp forbidden Verify the settings by entering the show gvrp configuration interface command CLI Reference Guide 204