D-Link DGS-6600-48T Product Manual - Page 229

DGS-6604 ip address-list ip address-list Use this command to specify the IP addresse range in a DHCP address pool and one of which is allowed to be bound with a DHCP client. Use the no form of this command to remove the range of IP addresses from the DHCP address pool. ip address-list IP-ADDRESS [,|-] no ip address-list IP-ADDRESS [,|-] Syntax Description IP-ADDRESS [,|-] The IP address list to be added into DHCP address pool. Default Command Mode Usage Guideline Example No IP addresses exist in any DHCP pool. DHCP pool configuration This command is used to define the IP address list for a DHCP pool. Reasonable IP addresses should be carefully defined for the pool. For example, use the same network ID or same subnet for the all IP addresses. Specify a host by specifying the IP address explicitly or specify a range of IP addresses using a hyphen between the start IP address and end IP address. Both the host and the range of IP addresses can be mixed together. Verify and confirm that the IP addresses chosen are part of the same network. This example shows how to configure the IP address range for pool1 in the IP address range of 10.1.1.1~10.1.1.255 and exclude the address 10.1.1.200 from the pool. Switch# configure terminal Switch(config)# ip dhcp pool pool1 Switch(config-dhcp)# ip address-list 10.1.1.1-10.1.1.255 Switch(config-dhcp)# no ip address-list 10.1.1.200 Switch(config-dhcp)# Verify the address pool is added with the show ip dhcp pool command. CLI Reference Guide 219