D-Link DGS-6600-48T Product Manual - Page 292

DGS-6604 ip ospf priority ip ospf priority Use this command to set the router priority to determine the designated router for the network. The no form of this command will reset the priority to the default value. ip ospf priority PRIORITY no ip ospf prority Syntax Description PRIORITY Specifies the priority of the router on the interface. The range is 0 to 255. Default Command Mode Usage Guideline Example PRIORITY: 1 Interface configuration Set the priority to help determine the OSPF Designated Router (DR) for a network. If two routers attempt to become the DR, the router with the higher router priority becomes the DR. If the router priority is the same for two routers, the router with the higher router ID takes precedence. Only routers with nonzero router priority values are eligible to become the designated or backup designated router. Configure router priority for multiaccess networks (not point-to-point) only. The following example shows setting the OSPF priority value to 3 on VLAN 1 interface. Switch# configure terminal Switch(config)# interface vlan1 Switch(config-if)# ip ospf priority 3 Verfiy the settings by entering the show ip ospf interface command. CLI Reference Guide 282