D-Link DGS-6600-48T Product Manual - Page 301

DGS-6604 ip pim dr-priority ip pim dr-priority Use this command to change the Designated Router Priority value inserted into the DR Priority option of the PIM Hello message. Use default command to return the setting to default. ip pim dr-priority PRIORITY default ip pim dr-priority Syntax Description PRIORITY The value of DR priority in the range of 0 to 4294967295. A larger value of this argument means a higher priority. Default Command Mode Usage Guideline Example PRIORITY: 1 VLAN interface configuration This command is only valid for the VLAN interface. This command is only effective for the SM mode. When a DR is a candidate for election, the following conditions apply: • The router with the highest priority value configured on an interface will be elected as the DR. If this priority value is the same on multiple routers, then the router with the highest IP address configured on an interface will be elected as the DR. • If a router does not advertise a priority value in its hello messages, the router is regarded as having the highest priority and will be elected as the DR. If there are multiple routers with this priority status, then the router with the highest IP address configured on an interface will be elected as the DR. The following example sets the DR priority of the vlan 1 interface to 200. Switch(config)# interface vlan1 Switch(config-if)# ip pim dr-priority 200 Verify the settings by entering the show ip pim interface command. CLI Reference Guide 291