D-Link DGS-6600-48T Product Manual - Page 305

DGS-6604 ip pim register-checksum-include-data ip pim register-checksum-include-data Use this command to configure the option to calculate the Register checksum over the whole packet. Use the no form of this command to disable calculating the Register checksum over the whole packet. ip pim register-checksum-include-data { group-list ACCESS-LIST-NAME} no ip pim register-checksum-include-data Syntax Description group-list Specifies the name of the basic IP access list name ACCESS-LIST-NAME Default Command Mode Usage Guideline Example Disabled By default, the Register Checksum is calculated only over the header. Global configuration This command is valid for SM mode and used to provide compatible interoperability with other manufacturer devices per the following: This command is used to inter-operate with some legacy CISCO® manufactured routers using older CISCO® IOS™ versions. This command is needed for the first hop router for encapsulation of the register packet. This function needs to be enabled in order to inter-operate with legacy CISCO® devices using older IOS™ versions. If group-list is not specified, then the setting will be applied to all groups. This command can be only specified once. The later applied command will override the previous setting. The following example shows how to enable register checksum over whole packet. Switch(config)# ip pim register-checksum-include-data Verify the settings by using the show ip pim command. CLI Reference Guide 295