D-Link DGS-6600-48T Product Manual - Page 307
ip pim rp-address, group-list, override], show ip pim
View all D-Link DGS-6600-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 307 highlights
DGS-6604 ip pim rp-address ip pim rp-address Use this command to statically configure the rendezvous point (RP) address for multicast groups. To remove an RP address, use the no form of this command. ip pim rp-address IP-ADDRESS [group-list ACCESS-LIST-NAME] [override] no ip pim rp-address IP-ADDRESS Syntax Description IP-ADDRESS IP address of a router to be a PIM RP. group-list ACCESS- (Optional) Specifies the name of multicast ACCESS-LIST for which multicast LIST-NAME groups that the RP should use. override If the access-list is not specified, the default multicast group is 224.0.0.0/4. (Optional) When there is a conflict between static RP configuration and the information learned by BSR, static RP configuration has the higher priority than the BSR learned information. Default Command Mode Usage Guideline Example None Global configuration This command is only valid for SM mode. Use this command to statically define the RP address for multicast groups that are to operate in sparse mode. A User can use a single RP for more than one group. The conditions specified by the access list determine which groups that the RP can use. A PIM router can define multiple RPs, but only one RP can be defined per multicast group. To configure the static-RP function in the PIM SM domain, this command needs to be configured across all of the routers in the PIM domain. Multiple RP addresses can be specified by the command. Only one access-list can be specified for an RP. The new setting overrides the old one. The following example sets the PIM RP address to 10.90.90.90 for multicast group 225.2.2.2 only: Switch(config)# ip access-list PIM-Control Switch(config-ip-acl)# permit any host 225.2.2.2 Switch(config-ip-acl)# exit Switch(config)# ip pim rp-address 10.90.90.90 group-list PIM-Control Verify the settings by using the show ip pim command. CLI Reference Guide 297