D-Link DGS-6600-48T Product Manual - Page 316

DGS-6604 ip rip receive version ip rip receive version Use this command to specify a RIP version to receive on each interface. Use the no form of the command to let the version follow the setting specified in the router configuration mode. ip rip receive version VERSION-ID [ , | - ] no ip rip receive version Syntax Description VERSION-ID The Version ID can be either 1 or 2. That is RIP accepts only RIP Version 1 packets on the interface or accepts only RIP Version 2 packets on the interface. It also can be a list of version IDs such as 1,2 (or 1-2), meaning that both RIP Version 1 and Version 2 packets are acceptable on the RIP enabled interface. Default Command Mode Usage Guideline Examples Global RIP version receive setting Interface configuration This command applies only to the interface being configured. The following example shows how to configure interface (VLAN 1) to accept both RIP Version 1 and Version 2 packets: Switch# configure terminal Switch(config)# interface vlan1 Switch(config-if)# ip rip receive version 1-2 Switch(config-if)# end The following example shows how to configure the interface (VLAN 1) to only accept RIP Version 1 packets: Switch# configure terminal Switch(config)# interface vlan1 Switch(config-if)# ip rip receive version 1 Switch(config-if)# end Verify the settings by entering the show ip rip interface command. CLI Reference Guide 306