D-Link DGS-6600-48T Product Manual - Page 329

DGS-6604 ipv6 access-list ipv6 access-list Use this command to create or modify an IPv6 access list. This command will enter into the ipv6 access-list configuration mode. Use the no form of the command to remove an IPv6 access-list. ipv6 access-list extended NAME no ipv6 access-list extended NAME Syntax Description NAME The name of the IPv6 access-list to be configured. A maximum of 32 characters. The syntax is a general string that does not allow spaces. Default Command Mode Usage Guideline Examples No IPv6 access list is defined. The access list defaults to an implicit deny statement for all traffic. Global configuration The name must be unique among all (including MAC, IP, and IPv6) access-lists. The characters are case sensitive. The maximum number of IPv6 access-list supported by the system is project dependent. An error message will appear if the allowed number is exceeded after the execution of the command. An IPv6 access list can not be deleted if it is applied to interfaces. The access list is always terminated by an implicit deny statement for all traffic. This example shows how to configure an IPv6 extended access-list, named ip6control. Switch(config)#ipv6 access-list extended ip6-control Swtich(config-ipv6-ext-acl)#permit tcp any 2002:f03::1 ffff:: Switch(config-ipv6-ext-acl)# This example shows how configure an IPv6 extended access-list, named ip6-stdcontrol. Switch(config)#ipv6 access-list extended ip6-std-control Swtich(config-ipv6-ext-acl)#permit tcp any fe80::101:1 ffff:ffff:ffff:: Switch(config-ipv6-ext-acl)# Verify the settings by entering the show access-list command. CLI Reference Guide 319