D-Link DGS-6600-48T Product Manual - Page 330

DGS-6604 ipv6 address ipv6 address This command is used to assign the IPv6 address to an interface of the switch. The no form of this command deletes the IPv6 address assigned to the interface. ipv6 address X:X::X:X/M no ipv6 address [X:X::X:X/M] Syntax Description X:X::X:X/M IPv6 network address. This argument must be in the form documented in RFC2373 where the address is specified in hexadecimal format using a 16-bit value between colons. X:X::X:X: IPv6 address M: IPv6 prefix length, maximum length is 64. Default Command Mode Usage Guideline Example None VLAN interface configuration The VLAN interface must be created first. If IPv6 is disabled, it will be enabled after the IPv6 address is configured. When using the no ipv6 address command without other parameters, it removes all ipv6 global addresses configured on this interface. This example shows how to add an IPv6 address to a VLAN interface: Switch > enable Switch # configure terminal Switch (config) # interface vlan1 Switch (config-if) # ipv6 address 3ffe:501:ffff:0:a01:2ff:fe39:1/64 Switch (config-if) # CLI Reference Guide 320