D-Link DGS-6600-48T Product Manual - Page 332

DGS-6604 Examples ipv6 address The following example shows how to enable IPv6 processing on the interface and configure an address based on the general prefix called my-prefix and the directly specified bits: Switch > enable Switch # configure terminal Switch (config) # interface vlan2 Switch (config-if) # ipv6 address my-prefix 0:0:0:1::1/64 Assuming the general prefix named my-prefix has the value of 3ffe:1:2::/48, then the interface would be configured with the global address: 3ffe:1:2:1::1/64. If no general prefix named my-prefix is set, then no IPv6 address will be set. If the general prefix named my-prefix is an acquired through a DHCPv6 Client prefix delegation, then the global address would be configured after the prefix is received from the DHCPv6 Client. The following example shows how to remove a general prefix named my-prefix on the interface: Switch > enable Switch # configure terminal Switch (config) # interface vlan2 Switch (config-if) # no ipv6 address my-prefix 0:0:0:1::1/64 The following example shows how to manually configure a global address: Switch > enable Switch # configure terminal Switch (config) # interface vlan2 Switch (config-if) # ipv6 address 3ffe:22:22:22::2/64 After the command is entered, the global address 3ffe:22:22:22::2/64 will be immediately set. The following example shows how to manually remove a global address from the configuration: Switch > enable Switch # configure terminal Switch (config) # interface vlan2 Switch (config-if) # no ipv6 address 3ffe:22:22:22::2/64 After the command is entered, the global address 3ffe:22:22:22::2/64 will be immediately removed. CLI Reference Guide 322