D-Link DGS-6600-48T Product Manual - Page 356

DGS-6604 ipv6 ospf shutdown ipv6 ospf shutdown To initiate an IPv6 OSPF protocol graceful shutdown at the interface level, use the ipv6 ospf shutdown command. To restart the OSPF protocol on an interface, use the no form of this command ipv6 ospf shutdown [IFNAME] no ipv6 ospf shutdown [IFNAME] Syntax Description IFNAME (Optional) Interface type and number. If no option is specified, apply to the whole IPv6 OSPF process. Default Command Mode Usage Guideline Example Disabled Router configuration Use the ipv6 ospf shutdown command to put IPv6 OSPF under a specific interface in shutdown mode. If no interface is specified for this command in router configuration mode, it will shutdown the protocol in the least disruptive manner and notify its neighbors that it is leaving. All traffic, that has another path through the network, will be directed to that alternate path. Note: When this command is used to shutdown IPv6 OSPF on all interfaces, then at this time the device will clear the LSDBs and leave them empty. This behavior is not the same as with the IPv4 OSPF protocol. The following example shows how to initiate an IPv6 OSPF protocol shutdown on the layer 3 interface (VLAN 1): Switch > enable Switch # configure terminal Switch (config) # router ipv6 ospf Switch (config-router)# ipv6 ospf shutdown vlan1 CLI Reference Guide 346