D-Link DGS-6600-48T Product Manual - Page 367

DGS-6604 ipv6 router ospf area ipv6 router ospf area To enable IPv6 OSPF on an interface, use the ipv6 router ospf area command. To disable IPv6 OSPF routing for interfaces defined, use the no form of this command. ipv6 router ospf area AREA-ID [tag PROCESS-ID] [instance-id INSTANCE-ID] no ipv6 router ospf area AREA-ID [tag PROCESS-ID] [instance-id INSTANCE-ID] Syntax Description AREA-ID The identifier of the area for which the vlan interface is to be enabled. It can be specified as either a decimal value or as an IPv4 address. PROCESS-ID (Optional) An internally used identification parameter for an IPv6 OSPF routing process. It is locally assigned and can be any positive integer. A unique value is assigned for each IPv6 OSPF routing process. INSTANCE-ID (Optional) Instance identifier. To change this ID, configure the "no" command first. The valid setting is from 0 to 255. Default Command Mode Usage Guideline Example IPv6 OSPF is disabled. PROCESS-ID: null INSTANCE-ID: 0 Interface configuration Before enabling IPv6 OSPF on an interface using the ipv6 router ospf area command, IPv6 must be enabled on the interface, and IPv6 routing must be enabled on the switch. There is no limit to the number of ipv6 router ospf area commands that can be used on the router. At least two interfaces must be configured for IPv6 OSPF to run. If the configuration is based on a specific process, then the no form of the command must include the process information. The following example enables IPv6 OSPF on an interface. Switch > enable Switch # configure terminal Switch (config)# interface vlan1 Switch (config-if)# ipv6 router ospf area 0 instance-id 2 CLI Reference Guide 357