D-Link DGS-6600-48T Product Manual - Page 376

DGS-6604 m lacp system-priority lacp system-priority Use the lacp system-priority command to configure the system priority used for LACP ports. Use the no form to configure the system priority to the default. lacp system-priority PRIORITY no lacp system-priority Syntax Description PRIORITY Specifies the system priority. The range is 1 to 65535. Default Command Mode Usage Guideline Example 32768. Global configuration During Link Aggregation Control Protocol (LACP) negotiation, the system priority and port priority of the local partner are exchanged with the remote partner. If the maximum number of actual members exceeds the limitation, the switch uses port priority to determine whether the port status will be in backup mode or active mode. The LACP system priority determines which switch controls the port priority for the aggreagated link. The port priorities of the other switch are ignored. In a system priority comparison, a numerically lower value has a higher priority. If two switches have the same system priority , the LACP system ID (MAC address) determines the priority. The LACP system priority command applies to all LACP port channels on the switch. This example shows how to configuration the system priority to 30000. Switch(config)# lacp system-priority 30000 Verify the settings with the show channel-group command CLI Reference Guide 366