D-Link DGS-6600-48T Product Manual - Page 381

DGS-6604 m lldp dot3-tlv-select lldp dot3-tlv-select To specify which optional type-length-value settings (TLVs) in the IEEE 802.3 Organizationally Specific TLV set will be transmitted and encapsulated in the LLDPDUs and sent to neighbor devices, use the lldp dot3-tlv-select command in Interface Configuration mode. To disable transmit the TLVs, use the no form of this command. lldp dot3-tlv-select [ mac-phy-cfg | link-aggregation | power | max-frame-size ] no lldp dot3-tlv-select [ mac-phy-cfg | link-aggregation | power | max-frame-size ] Syntax Description mac-phy-cfg (Optional) Specify the MAC/PHY Configuration/Status TLV to send. The MAC/PHY Configuration/Status TLV is an optional TLV that identifies:  The duplex and bit-rate capability of the sending IEEE 802.3 LAN node.  The current duplex and bit-rate settings of the sending IEEE 802.3 LAN node. link-aggregation (Optional) Specify the Link Aggregation TLV to send. The Link Aggregation TLV indicates contains the following information:  Whether the link is capable of being aggregated.  Whether the link is currently in an aggregation.  The aggregated port channel ID of the port. If the port is not aggregated, then the ID is 0. power max-frame-size (Optional) Specify the Power via MDI TLV to send. Three IEEE 802.3 PMD implementations (10BASE-T, 100BASE-TX, and 1000BASE-T) allow power to be supplied over the link for connected non-powered systems. The Power Via MDI TLV allows network management to advertise and discover the MDI power support capabilities of the sending IEEE 802.3 LAN station. (Optional) Specify the Maximum Frame Size TLV to send. The Maximum Frame Size TLV indicates the maximum frame size capability of the implemented MAC and PHY. When no optional keyword is selected, all supported IEEE 802.3 Organizationally Specific TLVs are selected or de-selected in no form of this command. CLI Reference Guide 371