D-Link DGS-6600-48T Product Manual - Page 400

DGS-6604 m logging level logging level Use this command to limit messages logged to the message buffer based on severity level. logging level all SEVERITY Syntax Description all All facilities SEVERITY Value for the severity level of system messages to capture. Severity level definitions are shown in the following table. Severity Level 0 1 2 3 4 5 6 7 Severity Type emergency alert critical error warning notice informational debugging Description system is unusable action must be taken immediately critical conditions error conditions warning conditions normal but significant condition informational messages debugging messages Default Command Mode Usage Guideline Example SEVERITY: 5 Global configuration The command limits the logging of system messages to the syslog buffer to only those messages for the specified facility at and up to the specified severity level. For example, if the buffer severity is 7 (debugging) then all logs in syslog daemon will log to buffer. If buffer severity is 1 (alert), then only alert and emergency logs will be logged to buffer. The below example limits logs with severity alert and emergency to be logged to buffer for all facilities. switch> enable switch# configure terminal Switch(config)# logging level all 1 Verify the settings by entering the show logging command. CLI Reference Guide 390