D-Link DGS-6600-48T Product Manual - Page 451

DGS-6604 m netbios node-type netbios node-type This command is used to configure the NetBIOS node's type for Microsoft Dynamic Host Configuration Protocol (DHCP) clients. Use the no form of this command to restore the configuration of the NetBIOS node's type back to default configuration (Hybrid). netbios node-type NTYPE no netbios node-type Syntax Description NTYPE Specifies the type of NetBIOS node. Valid types are listed below: • b-node - Broadcast • p-node - Peer-to-peer • m-node - Mixed • h-node - Hybrid (recommended) Default Command Mode Usage Guideline NTYPE: h-node DHCP pool configuration This command configures the NetBIOS node's type; the recommended type is hnode (Hybrid). It determines what methods NetBios will use to register and resolve names. • b-node - The broadcast system uses broadcasts. • p-node - A p-node system uses only point-to-point name queries to a name server (WINS). • m-node - An m-node system broadcasts first, and then queries the name server. • Hybrid - A hybrid system queries the name server first, and then broadcasts. Example Resolution through LMHOSTS and/or Domain Name Service (DNS), if enabled, will follow these methods. The following is sample of configuring the Netbios node type as h-node. switch# configure terminal switch(config)# ip dhcp pool pool1 switch(config-dhcp)# netbios node-type h-node CLI Reference Guide 441