D-Link DGS-6600-48T Product Manual - Page 454

DGS-6604 m network network Use the command to specify that the network utilizes Routing Information Protocol (RIP). To remove an RIP network entry, use the no form of this command. network NETWORK-PREFIX / MASK no network NETWORK-PREFIX / MASK Syntax Description NETWORK-PREFIX / The network prefix and the prefix length specify the destination network in the MASK form of xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx or xxx.xxx.xxx.xxx/x. Example: 10.9.18.2 255.0.0.0 or 10.9.18.2/8 Default Command Mode Usage Guideline Example Not configured Router configuration Use this command to specify networks to which routing updates are sent and received. If a network is not specified, the interfaces in that network will not be advertised in any RIP update. The following example shows how to define RIP as the routing protocol to be used on all interfaces connected to networks 192.168.70.0/24 and network 10.99.0.0/16 Switch# configure terminal Switch(config)# router rip Switch(config-router)# network 192.168.70.0/24 Swtich(config-router)# network 10.99.0.0/16 Switch(config-router)# end Verify the settings by entering the show ip protocols rip command. CLI Reference Guide 444