D-Link DGS-6600-48T Product Manual - Page 481

DGS-6604 m IEEE802.3af, it will be 16.9785W. This design is also for the better conformance of DGS-6600's PoE functionality. But we strongly recommend using 15.4W as the maximum power threshold in static mode. If PD only needs 15.4W, but the port is configured as maximum power threshold. That means PoE system will take 17W from system power budget and 1.6W will be wasted! The time range function could be also applied on PoE with a per-port based methodology. Once a PoE port is combined with a time-range profile, it will only be activated with the time range which that profile specified. The time-range profile must be created before it is applied. Example This example shows how to enable detection of a powered device and to automatically power a PoE port for interface eth3.1-3.5. Switch(config)# interface range eth3.1-3.5 Switch(config-if-range)# poe power-inline auto The following is an example showing how to configure a PoE interface eth3.1, allows class 1 or a class 2 powered device under 7000mw: Switch(config)# interface eth3.1 Switch(config-if)# poe power-inline static max 7000 This example shows how to disable powered-device detection and to not power a PoE port (eth3.1). Switch(config)# interface eth3.1 Switch(config-if)# poe power-inline never This example shows how to combine a time-range profile "rd_time" with PoE interface eth3.1. Switch(config)# interface eth3.1 Switch(config-if)# poe power-inline auto time-range rd_time You can verify your settings by entering the poe power inline status command. CLI Reference Guide 471