D-Link DGS-6600-48T Product Manual - Page 487

DGS-6604 m police aggregate police aggregate To configure a named aggregate policer as the policy for a traffic class in a policy map, use police aggregate command in the policy map class configuration mode. To delete the name aggregate policer from class policy, use the no form of this command. police aggregate NAME no police aggregate NAME Syntax Description NAME Specifies a previously defined aggregate policer name as the aggregate policer for a traffic class. Up to 32 characters are allowed. Default Command Mode Usage Guideline Example None Policy map class configuration Use the qos aggregate-policer command in global configuration mode to create a named aggregate policer, and then use the police aggregate command in the policy-map class configuration mode to configure the named aggregate policer as the policy for a traffic class. A named aggregate policer cannot be referred from different policy map. This example shows how to configure a named aggregate policer parameters and apply the policer to multiple classes in a policy map: An aggregate policer with single rate policing named agg_policer1 is created. This policer is configured as the policy for traffic class class1, class2, and class3. Switch(config)# qos aggregate-policer agg_policer1 64 128 exceed-action drop Switch(config)# policy-map policy2 Switch(config-pmap)# class class1 Switch(config-pmap-c)# police aggregate agg_policer1 Switch(config-pmap-c)# exit Switch(config-pmap)# class class2 Switch(config-pmap-c)# police aggregate agg_policer1 Switch(config-pmap-c)# exit Switch(config-pmap)# class class3 Switch(config-pmap-c)# police aggregate agg_policer1 Switch(config-pmap-c)# exit Verify the settings by entering the show policy-map command. CLI Reference Guide 477