D-Link DGS-6600-48T Product Manual - Page 495

DGS-6604 m power-saving power-saving Use the power-saving command to enable "Power Saving" function in the device. And use the no form of this command to disable "Power Saving" function. power-saving {phy} no power-saving {phy} Default Disabled Command Mode Global configuration. Usage Guideline The "power-saving" command can enable the "Power Saving" function on different hardware components. Currently, one component is supported: phy. Select the option "phy", it will set the PHY into "Power Saving" mode. The "no power-saving" command disables this function. The "PHY Power Saving" function could be enabled or disabled per-system base. There are two operation modes: "low-power" mode and "normal" mode. When power saving is enabled, the chips automatically enter "low-power" mode if the signal from a copper link partner is lost. They will go to normal mode when a signal is detected. Example If "PHY Power Saving" function is disabled, PHY will always be in normal mode no matter that the signal froma link partner is presented or not. The following example shows how to enable/disable "Power Saving" function. Switch(config)#power-saving Switch(config)# Switch(config)show power-saving Power-saving status phy power-saving:Enabled Switch(config)#no power-saving Switch(config)#show power-saving Power-saving status phy power-saving:Disabled CLI Reference Guide 485