D-Link DGS-6600-48T Product Manual - Page 505

DGS-6604 m qos dscp-mutation qos dscp-mutation To attach an ingress differentiated-services-code-point (DSCP) mutation map to the interface, use the qos dscp-mutation command in interface configuration mode. To remove the ingress DSCP mutation map from the interface, use the no form of this command. qos dscp-mutation DSCP-MUTATION-TABLE-NAME no qos dscp-mutation DSCP-MUTATION-TABLE-NAME Syntax Description DSCP-MUTATIONTABLE-NAME Name of the DSCP mutation table. The string of the name is up to 32 characters and no spaces are allowed. Default Command Mode Usage Guideline Example Not configured Interface configuration Only Physical port interfaces are supported, portchannel interface and vlan interface are not valid for this command. Use this command to attach an ingress DSCP mutation table to a physical port interface. Use the "qos map dscp-mutation" on page 499 to configure an ingress DSCP mutation table. The ingress DSCP mutation will mutate the DSCP value right after the packet is received by the physical port interface. This example shows how to map DSCP 30 to mutated DSCP value 8 and then attach the ingress-DSCP mutation map named mutemap1 to eth 3.1: Switch(config)#qos map dscp-mutation mutemap1 30 to 8 Switch(config)#interface eth 3.1 Switch(config-if)#qos dscp-mutation mutemap1 Switch(config-if)#end Verify the settings by entering the show qos interface command. CLI Reference Guide 495