D-Link DGS-6600-48T Product Manual - Page 507

DGS-6604 m qos map dscp-color qos map dscp-color To define the DSCP to color map for mapping of packet's initial color, use the qos map dscp-color command in interface configuration mode. To return the map to the default setting, use the no form of this command. qos map dscp-color DSCP-LIST to { green | yellow | red} no qos map dscp-color Syntax Description dscp DSCP-LIST Specifies the list of DSCP code point to be mapped to a color. The range of DSCP is 0 to 63. The multiple DSCP values in the list can be in the form 1, 2, etc. separated by commas, a continuous list such as 2-7, or a mixed form 1, 2, 3-10, 63,etc. Default Command Mode Usage Guideline Example DSCP-LIST: 0-63 mapped to green Interface configuration Only physical ports are valid for this command. When a packet enters the ingress port, it will be colored based on either the DSCP to color map (as the port is trust DSP) or CoS to color map (as the port is trust CoS). Use the qos map dscp-color command in interface configuration mode to configure the DSCP to color map. If the ingress port is set to trust DSCP, the received IP packet will be initialized to a color based on this map. The non-IP packet will be initialized to a color based on the CoS to color map. The following example defines DSCP61~63 as yellow color, others are green color at eth 3.1. Switch(config)# interface eth3.1 Swtich (config-if)# qos map dscp-color 61-63 to yellow Verify the settings by entering the show qos interface map command. CLI Reference Guide 497