D-Link DGS-6600-48T Product Manual - Page 566

DGS-6604 m sflow poller sflow poller Use the sflow poller command to create/configure a Poller for the sFlow agent. Use the no form of this command to delete one Poller or all Pollers. sflow poller INSTANCE [receiver RECEIVER][ interval SECONDS] no sflow poller [INSTANCE] Syntax INSTANCE receiver RECEIVER Interval SECONDS The instance index if multiple Pollers are associated with one interface. The range is from 1 to 65535. (Optional)The Receiver's INDEX for this Poller. If not specified, the value is 0. The user can not configure the value to 0. The maximum number is project dependent. (Optional)The maximum number of seconds between successive polling samples. The range is from 0 to 120. 0 means disable. If not specified, the default is 0. Default Command Mode Usage Guideline No Poller is created. Interface configuration mode. The command is available for physical port interface configuration. A Poller can only be configured on one interface. It cannot be associated with multiple interfaces. Use this command without keywords to create a default Poller or to reset an existing Poller to default values. Use the no form of this command with INSTANCE to delete one Poller. Use the no form of this command without INSTANCE to delete all Pollers. The user can only specify a Receiver that has its owner name setup. If the Receiver associated with the Poller has its owner name is reset, the Poller will be reset to the default setting. Setting the polling interval to 0 disables the polling.An interface can be configured with multiple Pollers. Example This example shows how to create/configure the Poller of INSTANCE 1 with RECEIVER as 1, and INTERVAL as 20 seconds. switch(config-if)# sflow poller 1 receiver 1 interval 20 CLI Reference Guide 556