D-Link DGS-6600-48T Product Manual - Page 582

DGS-6604 m show cpu-protect type show cpu-protect type Use this command to show the rate-limit and statistics of CPU protection show cpu-protect type { PROTOCOL-NAME [UNIT-ID] | unit UNIT-ID } Syntax Description PROTOCOL-NAME [UNIT-ID] unit UNIT-ID The configured rate-limit and statistics of the specified protocol on CM-Card and all existing IO-Cards will be displayed if the optional [UNIT-ID] is not specified. Otherwise, only the information on the specified unit id will be displayed. Specify the unit id which you want to display the rate-limit configuration and statistics. For chassis system device, the unit ID is equal to blade ID (or slot ID). Default Command Mode Usage Guideline Example none Privileged EXEC mode. Show configured rate limit and drop-count of Safeguard engine of specific group. These counters are counted by the software. There is probably deviation from the hardware received if the packets are dropped before sent to CPU. The following example is a sample output of show cpu-protect type command. N/A means no rate-limit is applied to this protocol. Switch# show cpu-protect type unit 1 Type Pps Total Drop stp 300 20 0 gvrp 400 24 0 lacp N/A 0 0 8021x 0 0 0 arp 0 0 0 icmpv4 0 0 0 icmpv6-neighbor 0 0 0 icmpv6-other 0 0 0 pim 0 0 0 rip 0 0 0 ospf 0 0 0 !--- Output suppressed. Switch# CLI Reference Guide 572