D-Link DGS-6600-48T Product Manual - Page 631

DGS-6604 m show ip dvmrp route Use this command to display DVMRP route information. show ip dvmrp route [ NETWORK-ADDRESS ] show ip dvmrp route Syntax Description NETWORKADDRESS (Optional) Specifies the source network address and mask length be displayed. If NETWORK-ADDRESS is not specified, all DVMRP routes will be displayed. Default Command Mode Usage Guideline Example None User EXEC or any configuration mode Display DVMRP route information. This example shows how to display route information. DGS-6600:15#show ip dvmrp route State: H = Hold-down Source Network Upstream Neighbor Metric Learned Interface State ExpTime 10.0.0.0/8 10.78.62.51 1 Local vlan99 - Total Entries: 1 DGS-6600:15# Display Field Descriptions Description of significant display fields. Display Field Source Network Upstream neighbor Learned Interface State ExpTime Description The address of the source IP address or source network. The Next hop router to the source network. 0.0.0.0: This route is a local interface entry, and therefore it does not enable DVMRP. If the interface is a local entry, then the upstream neighbor displays its own interface IP address. Indicates this route entry is a local interface. The other condition is dynamically learned. The local Interface used to connect to the source network. Route state displays "H" if the DVMRP route is in "Hold-down" state. The time remaining until the entry is removed from the DVMRP routing table. A dash note indicates this entry is not going to be removed (because it is a local interface). CLI Reference Guide 621