D-Link DGS-6600-48T Product Manual - Page 635

DGS-6604 m show ip igmp interface Used to display IGMP configuration information on interface show ip igmp interface [INTERFACE-ID [ , | - ] ] show ip igmp interface Syntax Description INTERFACE-ID [,|-] (Optional) Specifies a single interface, a range of interfaces separated by a hyphen, or a series of interface separated by a comma. If no interface is specified, the switch displays IGMP information for all interfaces where IGMP is enabled (that is for all of IGMP enabled interfaces). Note, only a VLAN interface type is allowed for this command. , (Optional) Specifies a series of interfaces, or separate a range of interfaces from a previous range. No space is allowed before and after the comma. - (Optional) Specifies a range of interfaces. No space is allowed before and after the hyphen. Default Command Mode Usage Guideline Example None User EXEC or any configuration mode User can display Interface IGMP configuration information by this command. If the specified VLAN interface has IGMP disabled, all of the IGMP related configuration shown as if IGMP is enabled with the exception that the IGMP state is disabled. When no VLAN interface is specified, only IGMP enabled VLANs are displayed for this command. While a VLAN interface list may incorporate IGMP disabled VLANs, all of the listed VLAN's IGMP configuration information is displayed. This example shows how to display IGMP configure information about interface VLAN 1000. Switch#show ip igmp interface vlan1000 vlan1000 IP Address/Netmask : 10.50.95.90/8 IGMP State : Enabled Access Group : igmp_fileter Version : 3 Query Interval : 125 seconds Query Maximum Response Time : 10 seconds Robustness Value : 2 Last Member Query Interval : 1000 milliseconds Querier : 10.50.95.90 Querier Timer countdown value : - Configured Query Interval : 5 Configured Maximum response time : 15 Configured Robustness : 2 CLI Reference Guide 625