D-Link DGS-6600-48T Product Manual - Page 698

DGS-6604 m show ipv6 interface brief show ipv6 interface brief These commands are used to display IPv6 interface summary information. show ipv6 interface IFNAME brief Syntax None Default None Command Mode EXEC mode or any configuration mode. Usage Guideline The [status/protocol] information is the same description with "show ip interface brief" command in the "Basic IPv4 command Reference Doc". An IPv6 interface can be in either down state or up state. As an interface is in up state, it can send and receive packets. If an interface is in down state, the directly connected routing entry is removed from the routing table. Removing the entry allows the software to use dynamic routing protocols to determine backup routes to the network. If you specify an optional interface type, you see information for that specific interface. At current stage, the supporting interface type is VLAN. If you specify no optional arguments, you see information on all the interfaces. If the interface hardware is usable, the interface is marked "up." For an interface to be usable, both the interface hardware and line protocol must be up. If the IPv6 address DAD fail, the IPv6 address is marked "DAD check fail" Example This example shows how to display IPv6 interface brief incidence: Switch > enable Switch #show ipv6 interface brief lo [up/up] unassigned vlan1 [up/up] 2010:312::1 fe80::a01:2ff:fe39:1 vlan2 [up/up] 2010:311::1 (DAD check fail) Switch # CLI Reference Guide 688