D-Link DGS-6600-48T Product Manual - Page 705

DGS-6604 m show ipv6 ospf neighbor show ipv6 ospf neighbor To display IPv6 OSPF neighbor information on a per interface basis, use the show ipv6 ospf neighbor command. show ipv6 ospf [PROCESS-ID] neighbor [IFNAME | NEIGHBOR-ID] [detail] Syntax Description PROCESS-ID (Optional) Internally used identification parameter for an IPv6 OSPF routing process. It is locally assigned and can be any positive integer. A unique value is assigned for each IPv6 OSPF routing process. IFNAME (Optional) Interface type and number. If no option is specified, the command applies to the entire IPv6 OSPF process. NEIGHBOR-ID (Optional) Neighbor ID. It can be specified as either a decimal value or as an IPv4 address. detail (Optional) Displays all neighbors in detail; lists all neighbors. Default Command Mode Usage Guideline Example None User EXEC The keywords can be appended to all other keywords used with the show ipv6 ospf neighbor command to display the information desired. The following is sample output from the show ipv6 ospf neighbor command with the detail keyword. Switch > enable Switch # show ipv6 ospf neighbor The result after executing this command is as follows. The result after executing this command is as follows. OSPFv3 Process (null) Neighbor ID Pri State Dead Time Interface 10.76.37.3 1 Full/DR 0DT0H0M33S vlan2 10.76.37.3 1 Full/ - 0DT0H0M38S VLINK1 Total Entries: 2 Instance ID 0 0 CLI Reference Guide 695