D-Link DGS-6600-48T Product Manual - Page 72

DGS-6604 based-on mac-address based-on mac-address This command is used to specify the host MAC address as a rule for IP address assignment from the DHCP address pool. Use the no form to remove the MAC address rule from the DHCP address pool. based-on mac-address MAC-ADDRESS [,|-] no based-on mac-address MAC-ADDRESS [,|-] Syntax Description MAC-ADDRESS [,|-] Specifies the MAC address list. Default Command Mode Usage Guideline Examples None DHCP pool configuration This command is used to create the address binding rule for the DHCP address pool. based-on mac-address command creates the address binding rules in an incremental way. That is, all of the mac-addresses created by the based-on macaddress commands take effect on the corresponding DHCP address pool. However this command will be combined using logical AND operations with the other rules is set by all other based-on commands. For example if the first rule is based-on mac-address 00:80:00:11:22:00- 00:80:00:11:22:FF and there is another based-on c-vid 200 command, the address pool will only assign an IP address to the client with a MAC address in range of 00:80:11:22:xx and with its C-VID=200. Other than that, no IP address is offered from the corresponding DHCP address pool. The following sets a rule used for IP address assignment based on MAC address 00:80:C8:11:22:xx from the DHCP address pool1. switch(config)#ip dhcp pool pool1 switch(config-dhcp)#based-on mac-address 00:80:C8:11:22:00-00:80:C8:11:22:FF The following sets an additional rule used for IP address assignment based on MAC address 00:80:C8:11:33:00 and 00:80:C8:11:33:FF from the DHCP address pool1. switch(config-dhcp)#based-on mac-address 00:80:C8:11:33:00,00:80:C8:11:33:FF CLI Reference Guide 62