D-Link DGS-6600-48T Product Manual - Page 728

DGS-6604 m show policy-map Use this command to display the policy map configuration. show policy-map [POLICY-NAME | interface INTERFACE-ID] show policy-map Syntax Description INTERFACE-ID (Optional) Module and port number. POLICY-NAME (Optional) Specifies the name of the policy map. If not specified, all policy maps will be displayed. Default Command Mode Usage Guideline Examples None User EXEC or any configuration mode The show policy-map command displays the class policies configured for the policy map. Use the show policy-map command to display all class policy configurations comprising any existing service policy map. The command show policy-map INTERFACE-ID displays the policy map configuration if the service policy has been attached to the specified interface. The following is sample output from the show policy-map command. As shown below, in the policy map called policy1, two-rate traffic policing has been configured for the class called police. Two-rate traffic policing has been configured to limit traffic to an average committed rate of 500 Mbps and a peak rate of 1 Gbps. Switch(config)#class-map police Switch(config-cmap)#match access-list acl_rd Switch(config-cmap)#policy-map policy1 Switch(config-pmap)#class police Switch(config-pmap-c)#police cir 500000 bc 10000 pir 1000000 be 10000 exceed-action set-dscp-transmit 2 violate-action drop Switch(config-pmap-c)#exit Switch(config-pmap)#exit Switch(config)#interface eth3.1 Router(config-if)#service-policy policy1 Router(config-if)#end CLI Reference Guide 718