D-Link DGS-6600-48T Product Manual - Page 74

DGS-6604 based-on s-vid based-on s-vid This command is used to specify the service provider vlan ID (S-VID) as a rule for IP address assignment from the DHCP address pool. Use the no form of the command to remove the S-VID rule from the DHCP address pool. based-on s-vid V-ID [,|-] no based-on s-vid V-ID [,|-] Syntax Description V-ID [,|-] Specifies the V-ID list. Default Command Mode Usage Guideline Examples None DHCP pool configuration This command is used to create the address binding rule for the DHCP address pool. The based-on s-vid command creates the address binding rules in an incremental way. That is, all of S-VID created by based-on s-vid commands take effect on the corresponding DHCP address pools. However this command will be combined using logical AND operations with the other rules set by other basedon commands. For example if the first rule is based-on s-vid 100 and there is another based-on c-vid 200 command, then the address pool will only assign an IP address to the client with C-VID=200 and S-VID=100. The following sets a rule used for IP address assignment based on S-VID 100 or 200 from the DHCP address pool1. switch(config)#ip dhcp pool pool1 switch(config-dhcp)#based-on s-vid 100,200 Below the rule becomes based on S-VID 100/ 200 and C-VID 1000. switch(config-dhcp)#based-on c-vid 1000 CLI Reference Guide 64