D-Link DGS-6600-48T Product Manual - Page 824

DGS-6604 m show poe power system show poe power system Use the command to display the setting and actual values of the whole POE system. show poe power system [unit UNIT-ID [,-]] {power-info | parameters} Syntax Description unit UNIT-ID (Optional) Specify the unit to be displayed. If no specified unit, all supported PoE units are displayed. The value range of UNIT-ID is between 3 o 6. , power-info parameters (Optional)You can specify a range of UNIT-ID by a hyphen, or a series of UNIT-ID by comma. There is no space before and after comma or hyphen. This option could display the power information such as allocated power、used power and unit priority of specific PoE unit. This option could display the parameters such as max ports、device ID、SW version、EEPROM status and configuration status for the PoE sub-system. Default Command Mode Usage Guideline Example None EXEC mode or any configuration mode This command could display the detail power information and PoE chip parameters for each PoE capable unit. As list of an UNIT-ID list is specified and not all of units in the list are PoE capable, only the PoE capable units are displayed. The delim sign for specifying unit list supports two choices: hyphen (-) or comma (,). The hyphen sign is used for displaying continuous units such as unit 2 to unit 4, and the format of the list will be "2-4". If you just want to check some units specifically like unit 3 and unit 4 which is not continuously arranged, and the comma sign can be used. This example shows how to display PoE power system's power information. CLI Reference Guide 814