D-Link DGS-6600-48T Product Manual - Page 839

DGS-6604 m snmp-server engineID local snmp-server engineID local Use this command to specify the SNMP engine ID on the switch. Use the no form of the command to remove a configured SNMP engine ID and return the engine ID setting to the original default value. snmp-server engineID local ENGINEID-STRING no snmp-server engineID local Syntax Description ENGINEID-STRING String length from 10 to 24 characters that identifies the engine ID. Default Command Mode Usage Guideline Example An SNMP engine ID is generated automatically but is not displayed or stored in the running configuration. Global configuration The SNMP engine ID is a unique string used to identify the switch for administration purposes.It is not necessary to specify an engine ID for the switch. For further details on the SNMP engine ID, see RFC 3411. To specify a manually configured ID, note that it is not necessary to specify the entire 24-character engine ID if the ID specified contains trailing zeros. Specify only the portion of the Engine ID up until the point where only zeros remain in the value. For example, to configure an engine ID of 123456789A00000000000000, specify an snmp-server engineID local as 123456789A. For a single SNMP engine system, changing the SNMP engine ID will overwrite the old SNMP local engine ID setting. Display the default or configured engine ID by using the show snmp engineID command. Note: If the SNMP engine ID is set to the default value then the no form of the command will fail when it is executed. This example shows how to configure the SNMP engine ID to 123456789A00000000000000. Switch(config)# snmp-server engineID local 123456789A Verify the settings by entering the show snmp engineID command. CLI Reference Guide 829