D-Link DGS-6600-48T Product Manual - Page 863

DGS-6604 m spanning-tree port-priority spanning-tree port-priority This setting is used to configure the value of the STP port priority on a specified port. It is only used for RSTP and STP version. Use the no form of this command to reset to the default priority. spanning-tree port-priority PRIORITY no spanning-tree port-priority Syntax Description PRIORITY Specifies the port priority; valid values are from 0 to 240. Default Command Mode Usage Guideline PRIORITY: 128 Interface configuration The port priority and the port number together form the Port Identifier. It will be used in the computation of the port's role. This parameter is used only in RSTP / STP-Compatible mode only. The port priority value must be divisible by 16, and a lower priority value (number) represents a higher priority. Both of the physical port or port-channel interfaces are valid interfaces for configuration. An error message will be returned if the priority is not a valid value. Example This example shows how to configure the port priority to 0 for eth3.7. Switch(config)#interface eth3.7 Switch(config-if)#spanning-tree port-priority 0 Verify the settings by entering the show spanning-tree interface command. CLI Reference Guide 853