D-Link DGS-6600-48T Product Manual - Page 872

DGS-6604 m storm-control level (Interface) storm-control level (Interface) This command configures the rising threshold for Storm Control function. Use no command to return the default settings. storm-control {broadcast | multicast | unicast} level {LEVEL | pps PPS} no storm-control {broadcast | multicast | unicast} level Syntax Description Broadcast Set Broadcast rate limiting Multicast Set Multicast rate limiting Unicast Set Unicast(DLF) rate limiting level LEVEL Specifies the rising threshold as a percentage (0 to 100) of total bandwidth of the port. level pps PPS Specifies the rising threshold as a rate in packets per second at which traffic is received on the port. The range of PPS is from 1 to 148810 (for 100 Mbps). For 1000 Mbps, the range is 1 to 1488100 and so on. Default Command Mode Usage Guideline Examples level pps PPS: 131072 packets per second Interface configuration Only a physical port interface is valid for this command. The precise suppression level, as a percentage (0 to 100) of total bandwidth of specific port interface, is not able to be calculated exactly. That is, the current calculation formula assumes that the packet size of all incoming packets is 1512 bytes. This example shows how to configure Broadcast storm control LEVEL by pps mode. It assigns the pps threshold level of interface eth3.1 for incoming broadcast packets to 500 and drops the packets that exceed the threshold. Switch# configure terminal Switch(config)# interface eth3.1 Switch(config-if)# storm-control broadcast level pps 500 Switch# show storm-control interface broadcast Interface Storm Action Type Threshold eth3.1 Broadcast Drop pps 500 CLI Reference Guide 862