DELPHI SA10085 User Guide - Page 21
Removing swivel mount from your, dashboard
UPC - 689604157787
View all DELPHI SA10085 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Section 5 21 adhere to the vehicle's surface. Make sure you accurately place the pad on the first try since in many cases it will bond almost immediately. 3M recommends a 72-hour curing time for maximum adhesion. 3. Clip the Roady2 onto the swivel or vent mount (figure 7). 4. Reassemble the system as in step 1, To vehicle dashboard inserting cassette audio adaptor into the vehicle's cassette deck and the 12V power adaptor into the cigarette lighter. 5. Attach the antenna as explained on page 22 and route the antenna cable as described on page 24. Figure 7. Attach car mount to back of Roady2 as shown. Removing swivel mount from your dashboard You can remove the swivel mount from your dashboard by taking the following steps: 1. Lift one edge of the adhesive pad gently with fingers or the rounded edge of a spoon. Once enough of the edge is loosened to grip with your fingers, pull the pad gently from the mounting surface at a 90-degree angle. Avoid using sharp tools that could damage the vehicle's interior. 2. If the pad fails to loosen, first warm it with a hair dryer for 2 to 3 minutes to soften the adhesive. Be careful not to apply too much heat, which could damage the mounting surface. 3. If any adhesive remains on the dashboard surface, the adhesive can easily be removed by rubbing your thumb or finger across it. 4. As necessary, use a mild household cleaner to clean the dashboard surface. Caution: Never use a commercial heat gun or paint-stripping gun. This could result in damage to the unit or to your vehicle.