Dacor DHD48MW Installation Instructions
Dacor DHD48MW Manual
 |
View all Dacor DHD48MW manuals
Add to My Manuals
Save this manual to your list of manuals |
Dacor DHD48MW manual content summary:
- Dacor DHD48MW | Installation Instructions - Page 1
Installation Instructions Modernist Range Hood DHD30M967WM, DHD36M976WM, DHD48M987WM, DHD30M967WS, DHD36M976WS, DHD48M987WS Part No. 110452 RevB - Dacor DHD48MW | Installation Instructions - Page 2
service information 4 If You Need Help... 4 Important safety instructions 5 Related equipment safety 5 Important Information about safety instructions the Mounting Location 24 Marking the Centerlines 25 Installing the Support Brackets 26 Blower Rotation (Rear Exhaust) 27 Remove and - Dacor DHD48MW | Installation Instructions - Page 3
• In the interest of safety and to minimize problems, read these installation instructions completely and carefully before you begin the installation process. • Leave these installation instructions with the customer. Customer • Keep these installation instructions for future reference and the local - Dacor DHD48MW | Installation Instructions - Page 4
information If You Need Help... ...with questions or installation problems, contact your Dacor® dealer or the Dacor Customer-Service Team. For under-warranty repairs to Dacor appliances, call the Dacor Distinctive Service line. When you call, be prepared with the appliance's model and serial number - Dacor DHD48MW | Installation Instructions - Page 5
and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. • Always contact the Dacor Customer Service Team about problems and conditions that you - Dacor DHD48MW | Installation Instructions - Page 6
Use the hood only as outlined in this manual. Do NOT use the hood to vent installer according to procedures in this guide. Have the installer show you the instructions and the requirements specified by the manufacturer of the cooktop or range. Improper installation, adjustment, alteration, service - Dacor DHD48MW | Installation Instructions - Page 7
instructions • Do not install/repair/replace any part of the range hood unless specifically recommended by the procedures in this guide. A qualified service technician should perform all other service. Contact the nearest Dacor authorized service Consult the instructions in this manual for the - Dacor DHD48MW | Installation Instructions - Page 8
Important safety instructions Important safety instructions WARNING • TO REDUCE RISK OF PERSONAL INJURY FROM A GREASE FIRE: - CAREFULLY SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off - Dacor DHD48MW | Installation Instructions - Page 9
with foil tape. See Pg. 21-23. ‰ The hood is wired/grounded as instructed and per all applicable electric codes. See Pgs. 18-19. ‰ Filters are assembled as instructed on Pg. 30. ‰ The setup was verified. ‰ Any problems were noted on the warranty card or during the online warranty activation. The - Dacor DHD48MW | Installation Instructions - Page 10
Installation requirements Prepare to install the hood Have these tools and hardware within reach before you start the installation. Phillips screwdriver Flathead screwdriver Pencil/marking tool Wire connector caps Wire stripper Drill, bits Hood Installation Level Junction box Jigsaw 8" Ducting - Dacor DHD48MW | Installation Instructions - Page 11
, Hardware Dimmable LED light bulbs (2) 48" (4), 36" (3), 30" (2) Light-replacement tool (1) Product literature** (2) Dacor cleaning cream (1) stainless steel units only * Ready-to-assemble kit ** Installation instruction, User manual. Installation requirements English 11 - Dacor DHD48MW | Installation Instructions - Page 12
Installation requirements Installation Planning • A qualified technician must complete the installation of this built-in appliance. Proper installation is the customer's responsibility. • Carefully check the location where the Hood is to be installed. The Hood should be placed for convenient access - Dacor DHD48MW | Installation Instructions - Page 13
Individual Models: DHD30/36/48 Components Lights Filters Blowers Exhaust Vents Blower Rating 48" 4 2 1200 CFM Weight Specifications Individual Models: DHD30/36/48 Model 30 36 48 Individual Models: DHD30/36/48 Model 30 36 48 Top Vent x x x 36" 3 1 600 CFM 30" 2 1 600 CFM Weight 53 lbs (24 kg - Dacor DHD48MW | Installation Instructions - Page 14
Installation requirements Electrical/Ductwork Connections Connect electrical wires and ductwork through the top or rear of the hood. Before installing the hood, mark the access holes according to the diagrams below. (Tolerances: +1/16" -0", unless otherwise stated.) Top Connections: All models - Dacor DHD48MW | Installation Instructions - Page 15
Rear Connections: All models (2) ElectricalAccess Holes 7/8 in. (5.1 cm) dia. 19 3/4 in. (50.2 cm) Hood C/L 9 7/8 in. (25.1 cm) *See table 5 3/4 in. (14.6 cm) Single-Exhaust Standard 8" duct Dual-Exhaust Standard 8" duct Hood bottom Dimensions: Rear Electrical Access Holes (DHD 30/36/48) - Dacor DHD48MW | Installation Instructions - Page 16
Installation requirements Dimensions (Hood) Tolerances: +1/16" -0" unless otherwise stated. Single Blower DHD30/36 Series DHD Hood Dimensions Model 30 36 48 A 29 7/8" (75.9 cm) 35 7/8" (91.1 cm) 47 7/8" (121.6 cm) Dual Blower DHD48 Series B 24" (61 cm) C 18" (45.7 cm) D 12" (30.5 cm) - Dacor DHD48MW | Installation Instructions - Page 17
Cabinet-Layout Dimensions All tolerances: +1/16" -0", unless otherwise stated. Electrical access (top and back of hood) 30" min. (76.2 cm) * hood bottom to cooking surface Installation requirements Min. Width of E (Upper-Cabinet Cutout, Appliance Width) Model DHD E 30 30" (76.2 cm) 36 - Dacor DHD48MW | Installation Instructions - Page 18
Installation instructions Meeting Electrical Codes • The owner shall verify that all electrical requirements are met by the qualified electrician servicing this appliance. • The electrical installation (incl. minimum supply-wire size and grounding) must comply with the National Electric code ANSI/ - Dacor DHD48MW | Installation Instructions - Page 19
. Suggested Junction Box Area Hood 1. In the cabinet or wall, drill 7/8" holes through which to pass the electrical wiring. 2. See the last pages of this guide for wiring diagrams. Installation instructions English 19 - Dacor DHD48MW | Installation Instructions - Page 20
Installation instructions Meeting Installation Requirements • The hood must be at least as sturdy, solid, and at right angles. • Install the hood so it can be removed for service. • WARNING • Follow local codes during planning/installation. Contact the local building department for details. Use - Dacor DHD48MW | Installation Instructions - Page 21
, the blower can be rotated to vent through the rear (B, above). When planning ductwork, always find the shortest, most direct route to the outside. Installation instructions English 21 - Dacor DHD48MW | Installation Instructions - Page 22
Installation instructions Duct-Length Calculation Table The type of duct determines the hood's maximum straight duct length. To determine your feet 5 feet 2 feet 25 feet 4 feet * *Equivalent lengths of roof and wall caps vary with model and configuration. Installation instructions 22 English - Dacor DHD48MW | Installation Instructions - Page 23
then seal with certified duct/foil tape. Never join ducting with tape only. • Support the weight of the ducting with sheet-metal screws as needed. • To avoid backdraft temporary holding brackets to support the hood only until the hood is permanently anchored. English 23 Installation instructions - Dacor DHD48MW | Installation Instructions - Page 24
Installation instructions Planning the Mounting Location Holding brackets and hardware are provided to support the hood so you can permanently anchor it to the wall. The illustrations below show the purpose of the holding brackets and the support behind the wall. Adjacent Cabinetry Bracket - Dacor DHD48MW | Installation Instructions - Page 25
and level the hood, and mark the duct cutouts. Have a marking tool, tape measure, and level ready. Dual Exhaust Single Exhaust Installation instructions Cooktop Top-Exhaust Centerline 1. Position the hood as it will be when installed (e.g., for a top-vent installation, set the hood with the - Dacor DHD48MW | Installation Instructions - Page 26
Installation instructions Installing the Support Brackets CRITICAL: To avoid alignment issues during final and align the screw holes with the horizontal centerline. (Use anchors/screws that can support the hood; be sure to properly reinforce drywall installations.) 5. Mark the two holes - Dacor DHD48MW | Installation Instructions - Page 27
before you hang the hood. WARNING • Install the hood only if the electrical service meets the hood's specifications; the owner shall verify proper installation. • Observe all • 10" ducts, ducting material 8" Duct and ducting materials Phillips screwdriver Installation instructions English 27 - Dacor DHD48MW | Installation Instructions - Page 28
Installation instructions Remove and Replace parts Disassembling Parts 1. Unhook and remove the grease channel. 2. (Taking care not to scratch the remove the hardware that holds the blower and L-bracket. 4. Detach the blower and plate, and set them aside. Installation instructions 28 English - Dacor DHD48MW | Installation Instructions - Page 29
I/O port faces right, and its exhaust port is against the L- bracket at the rear of the hood. Right Side Hood resting on its top Installation instructions English 29 - Dacor DHD48MW | Installation Instructions - Page 30
Installation instructions Finalizing the Rear-Vent Setup Duct collar Rear Right Top 1. Refasten the cable clamps and assembly to hood. Replacement Part # 702579 702580 Description Baffle Filter Kit (1 pc + hardware) Baffle Filter Kit (2 pc + hardware) Installation instructions 30 English - Dacor DHD48MW | Installation Instructions - Page 31
a 3/4" flange around the base. Bending the Flanges On the Transition Duct Top/rear vent: Models DHD30/36/48 All four corners bent out 90° Installation instructions English 31 - Dacor DHD48MW | Installation Instructions - Page 32
Installing the AHT10 Transition Kit Top-/Rear-Vent Configuration This procedure instructs you how to install the AHT10 Transition Kit for top- and rear- vent configurations AHT10 unit to the hood. 4. With foil tape/duct tape, seal the AHT10 unit's base. Installation instructions 32 English - Dacor DHD48MW | Installation Instructions - Page 33
the hood. IMPORTANT: Hanging slots in the hood back engage the holding brackets to support the hood temporarily during installation. Adjacent Cabinetry Bracket slot (on hood back) Bracket attached . 9. Adjust and anchor the hood to its final position. Installation instructions English 33 - Dacor DHD48MW | Installation Instructions - Page 34
Installation instructions Hardwiring the Hood Power may be suppled to the hood through an electrical junction box or a dedicated 15Amp. circuit breaker Access 1. Shut power OFF at the circuit breaker or fuse box. 2. Feed the cable assembly through the hood. Installation instructions 34 English - Dacor DHD48MW | Installation Instructions - Page 35
Insert the white wire and black wire through the plastic hole protector, and tightly connect the wires to their corresponding terminals. Installation instructions Bottom To house circuit breaker or fusebox Junction box GREEN GREEN WHITE WHITE BLACK BLACK Wire nut (3 places) To range hood UL - Dacor DHD48MW | Installation Instructions - Page 36
NEMNAEMsAtrsatirnainrerelilieeff Junnccttioionnbobxox TTo RannggeeHHoooodd MMeeterr NoN.o4. 4cocoppppeerr wwiriree Clammppss BBaarree mmetaall InInssuullaatteedd Pipe Juummppeerr ((iiff nneecceessssaarryy)) Grounding by External Cold-Water Pipe Installation instructions 36 English - Dacor DHD48MW | Installation Instructions - Page 37
the suction cup. 4. Switch the main circuit power ON. Suction Cup Replacement Part # 702666 Description Dimmable LED Bulb Replacement Kit (1 bulb + 1 suction-cup tool) Installation instructions English 37 - Dacor DHD48MW | Installation Instructions - Page 38
Installation instructions Verifying the Setup OFF ON Grease Channel Filter Main Power Switch Detail/ Hood Bottom Main Power Switch Front Filter Clip : to verify that the fan speed increases each time. 10. Press POWER again to turn the fan OFF. Bottom Installation instructions 38 English - Dacor DHD48MW | Installation Instructions - Page 39
. 3. Verify that the electrical connections are correct. 4. Perform the Verifying the Setup procedure again. IMPORTANT: If the hood still does not work, contact Dacor Distinctive Service: (800) 793-0093 x2822. Do not try to repair the hood yourself. Dacor is not responsible for - Dacor DHD48MW | Installation Instructions - Page 40
Installation instructions Wiring Diagram DHD30/36/48 WIRING DIAGRAM DHD30, 36, 48 SERIES NOTE DHD30: 2 LIGHTS, 1 FAN DHD36: 3 SINGLE-PHASE POWER SUPPLY 10K THERMISTOR P/N: 110301 CAUTION: DISCONNECT POWER SUPPLY AT FUSE BOX BEFORE SERVICING THIS EQUIPMENT Installation instructions 40 English - Dacor DHD48MW | Installation Instructions - Page 41
MEMO - Dacor DHD48MW | Installation Instructions - Page 42
MEMO - Dacor DHD48MW | Installation Instructions - Page 43
MEMO - Dacor DHD48MW | Installation Instructions - Page 44
Dacor ∙ 14425 Clark Avenue, City of Industry, CA 91745 ∙ Phone: (800) 793-0093 ∙ Fax: (626) 403-3130 ∙ www.dacor.com
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
 |
 |
Installation Instructions
Modernist Range Hood
DHD30M967W
M
, DHD36M976WM, DHD48M987WM,
DHD30M967WS, DHD36M976WS, DHD48M987WS
Part No. 110452 RevB