Dell 1250C User's Guide - Page 79
Printing a Device Settings Resetting Defaults - led printer
View all Dell 1250C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
12 Jam Y - Toner MC 3 4 5 7 8 Cause/Remedy Error Ready/ Start Manual Load K Data Duplex Paper - - An error occurred while downloading the firmware. Turn off the printer, and then on. Printing a Device Settings Page Press and hold the (Start) button when the Ready/Data indicator lights (ready status) until the Ready/Data indicator blinks. Resetting Defaults After executing this function and rebooting the printer, all the menu parameters are reset to their default values. 1 Turn off the printer. 2 Open the rear cover. 3 While holding down the (Start) and the (Cancel) buttons at the same time, turn on the printer. 4 After the Orange LED on the Ready/Data indicators go out, release the (Start) and (Cancel) buttons. 5 Close the rear cover. • Initializes the non-volatile memory (NVM). CAUTION: Never attempt to turn off the printer. The printer will cease to function. The printer restarts automatically to apply the settings and prints the printer settings and device settings pages. 6 Check if the factory settings are restored by referring to the Printer Settings and Device Settings pages. Operator Panel 77