Dell Dimension 2400 Owner's Manual - Page 56

Position the top of the floppy drive bracket so that it is completely flush with the bottom

Get Dell Dimension 2400 PDF manuals and user guides View all Dell Dimension 2400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

www.dell.com | support.dell.com tabs (2) insert 8 Connect the floppy-drive power cable to the back of the drive. CAUTION: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1"). 9 Connect the data cable to the back of the drive and to the floppy drive connector on the system board (see page 51). 10 Position the top of the floppy drive bracket so that it is completely flush with the bottom of the upper drive bay, and then slide the floppy drive bracket forward into place. NOTE: The top of the floppy drive bracket has two slots that fit into two clips on the bottom of the upper drive bay. When the floppy drive bracket is properly mounted, it remains in place without support. 56 Removing and Installing Parts

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
56
Removing and Installing Parts
www.dell.com | support.dell.com
8
Connect the floppy-drive power cable to the back of the drive.
CAUTION:
Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
9
Connect the data cable to the back of the drive and to the floppy drive connector on the
system board (see page 51).
10
Position the top of the floppy drive bracket so that it is completely flush with the bottom of
the upper drive bay, and then slide the floppy drive bracket forward into place.
NOTE:
The top of the floppy drive bracket has two slots that fit into two clips on the bottom of the upper
drive bay. When the floppy drive bracket is properly mounted, it remains in place without support.
insert
tabs (2)